Foxconn N15235 Motherboard Front Panel Connectors May 2026

The is a legacy micro-ATX board commonly used in pre-built systems from the early 2010s. While reliable, finding official documentation for its front panel connectors (power switch, reset, HDD LED, power LED) is notoriously difficult because Foxconn manufactured these boards specifically for OEMs (Original Equipment Manufacturers) like Acer and eMachines.

Disclaimer: This pinout is based on the most common revision (Rev 1.0/1.1) of the Foxconn N15235. Minor OEM variations exist. When in doubt, test with a multimeter.

A: Possibly, but check the pinout. Many OEM cases (Acer, Dell) use proprietary block connectors that are not compatible. You may need to cut the block and separate the wires. foxconn n15235 motherboard front panel connectors

A: No. The front panel is purely hardware-controlled. Check BIOS only for “Power On By Keyboard/Mouse” – unrelated to physical buttons.

Published by : Tech Hardware Guides Reading Time : 8 minutes The is a legacy micro-ATX board commonly used

Adding to the confusion, many pre-built cases (e.g., from Acer) use a single, consolidated block connector rather than individual tiny plugs. If you are transplanting this motherboard into a standard aftermarket case, you will encounter the seven tiny two-pin connectors (POWER SW, RESET SW, HDD LED, POWER LED+/-). Without a pinout, it is like solving a puzzle with no picture.

If you have landed on this page, chances are you are staring at a bare Foxconn N15235 motherboard pulled from an Acer Aspire, a Packard Bell, or an old office PC. You see a cluster of small, metal pins in the bottom-right corner, and you have no idea which wire goes where. You are not alone. Minor OEM variations exist

A: Absolutely. The N15235 uses standard ATX front panel pin spacing (2.54mm). Any modern case’s front panel cables will fit. Just follow the pinout in Section 3.