However, like any sophisticated electronic device, its full potential is only unlocked through proper configuration. This is where the becomes indispensable. Whether you are an electrician, maintenance engineer, or a DIY automation enthusiast, this article serves as a comprehensive companion to the official manual, covering installation, parameter settings, fault codes, and where to download the latest PDF. Chapter 1: Model Breakdown – Understanding “CHE100-0R7G-S2” Before diving into the manual, let’s decode the model number, as the manual refers to these specifications constantly:
Introduction The INVT CHE100-0R7G-S2 is a compact, high-performance variable frequency drive (VFD) designed for controlling single-phase AC motors. As part of INVT’s renowned CHE100 series, this specific model—denoted by 0R7G (0.75kW) and S2 (single-phase 220V input)—is widely used in small conveyors, fans, pumps, and industrial machinery. invt che100-0r7g-s2 manual
| Fault Code | Description | Likely Cause & Solution (from manual) | | :--- | :--- | :--- | | | Overcurrent during acceleration | – Acceleration time too short (increase P0-06). – Motor short circuit (check U,V,W wiring). | | E.OU1 | Overvoltage during deceleration | – Deceleration time too short (increase P0-07). – Add braking resistor (manual shows TB/TA wiring for brake). | | E.LU | Low voltage | – Input voltage drops below 170V. Check L/N connections or supply stability. | | E.OH | Overheat | – Heatsink temperature >85°C. Clean fan or improve ventilation. | | E.SC | Motor short circuit | – Immediate trip. Power off, measure resistance U-V, V-W, W-U (should be equal, > few ohms). | | E. EF | External fault | – Terminal S input configured as external fault has been triggered. | However, like any sophisticated electronic device, its full
| Parameter | Name | Recommended Value for 0.75kW Motor | | :--- | :--- | :--- | | P0-01 | Motor control mode | 0 (V/F control) or 1 (Sensorless vector) | | P0-03 | Max output frequency | 50.00 Hz (or 60.00 Hz for North America) | | P0-04 | Upper limit frequency | 50.00 Hz | | P1-00 | Motor rated power | 0.7 kW (or 0.75 kW depending on motor plate) | | P1-01 | Motor rated voltage | 220 V | | P1-02 | Motor rated current | Find value from motor nameplate (typical: 3.5–4.2A) | | P1-03 | Motor rated frequency | 50 Hz or 60 Hz | | P1-04 | Motor rated speed | e.g., 1420 RPM (for 4-pole 50 Hz) | – Motor short circuit (check U,V,W wiring)